Laney Website
Lionheart represents everything we've learned through forty years of Laney tube heritage, distilled into a single ampilfier range. Designed to deliver the ultimate tone of a tube being pushed hard - warm and expressive, at an output level which can be used in everyday environments. This twin channel, all tube amplifier features 'Parallel single-ended' Class A output from 4x EL84 matched tubes, providing 20 watts of rich tube power, delivered into 4x 10" Jensen P10-R drivers. The L20T-410 also features gold plated PCB's and jack sockets. Sealed gold contact relays are used in all signal paths for minimum sound coloration, and the amp comes fitted with the renowned "Type 4" large spring linePower RMS 20 Watts
Inputs 2x Jack, Hi & Lo
Channels Clean & Drive
Equalisation Passive Bass, Middle and Treble
Bright Switch Yes
Preamp Valves 3x 12ax7
Output Valves 4x EL84
Class Class A
Reverb Yes
Footswitch FS2 (Included)
Speaker connections 3x Jacks
FX Loop(s) Yes
Impedance 4, 8 and 16 ohm
Drivers 4x10" Jensen P10-R
Baffle Marine Grade Plywood Cabinet Design Marine Grade Plywood cabinet with retro banding strip, leather strap handle and folding tilt back mechanism
Weight 30.5 Kg
Dimensions Width 562 x Height 639 x Depth 288
Channel Controls Gain (Clean), Gain & Volume (Drive)
Master Section Global EQ, Reverb and Tone controls
The range of VC30 combos offer classic British class A tone in a variety of speaker options. The VC30 features 2 footswitchable channels, with three band EQ on the drive channel and a bright switch. If you're looking for that elusive living tone then look no further than the VC30. The VC30-212 is the classic retro option and features a pair of 12" Custom designed 35 watt drivers. The VC30 generates very little cross over distortion because it runs in pure class A mode - its valves are always hot and ready to roll, which gives it that unmistakable class A sound and feel. If you've never experienced that level of connection between a player, an amp and a tone, then you've never tried this one.
Power RMS 30 Watts
Inputs Hi & Lo Jacks
Channels 2
Equalisation Bass, Middle, Treble
Bright Switch Yes: On Clean Channel
Preamp Valves Premium ECC83
Output Valves Premium EL84
Class Class A
Reverb Yes
Footswitch FS2 (Not included)
Speaker connections Jack
FX Loop(s) Yes
Impedance Minimum 4 ohms
Drivers 2 x 12" Celestion 70 Eighty
Weight 28.5 Kg
Dimensions 520 x 676 x 250
The LC30-112 is the epitome of class A tone. A road-ready combo that packs 30 watts RMS of real tube punch to cut through when playing live. The Laney LC30-112 offers independent GAIN and DRIVE controls on each channel - giving you maximum tonal flexibility. Along with independent equalisation for both Clean and Drive channels and a switchable spring reverb. The new TONE control allows you to quickly add tonal colour to your sound and functions in the same way as your guitar tone control.
Power RMS 30 Watts
Inputs Hi & Lo Jacks
Channels 2
Equalisation Independent Bass, Middle & Treble for both channels
Bright Switch Yes: On Clean Channel
Preamp Valves Premium ECC83
Output Valves Premium EL84
Class Class A
Reverb Yes
Footswitch FS2 (Not included)
Speaker connections Jack
FX Loop(s) Yes
Drivers 1x 12" Celestion Seventy 80 Driver
Weight 23 Kg
Dimensions 476 x 565 x 330
The TT50H - a 50-watt head, featuring a completely new pre-amp. Three channels Clean, Crunch & Lead each feature independent three band EQ, volume, bright switch and reverb. The two gain channels feature a Modern Switch which gives you super smooth response whilst the Lead channel features an additional Xpand and boost switch. Xpand breathes life back into your tone at high gain. The power section features two independent footswitchable master volumes, allowing you to give yourself a boost whatever channel you are on, great for the clean lead breaks. All footswitchable features on the TT50/100 amplifiers are fully MIDI switchable and each amp is equipped with MIDI in, MIDI thru & MIDI. This head works well with the TT412A cabinet (see below). Any cabinet can be used if the impedance is matched correctly.
Power RMS 50 Watts
Inputs Single Jack
Channels 3
Equalisation Independent Bass, Middle & Treble for each channel
Master Presence Control Yes
Bright Switch 3: 1 per channel
Xpand Switch Yes (on channel 3)
Boost Switch Yes (on channel 3)
Modern Switch Yes (on channel 3)
Switchable Damping Yes
Twin Footswitchable Master Volumes Yes
Preamp Valves Premium ECC83
Output Valves Premium EL34
Class A/B
Reverb Yes- With independent levels on each channel plus global master level
Line Out Yes
Record Out Yes
Footswitch FS6 (Included)
Speaker connections Connections for 1 x 16 ohm, 2 x 16 ohm, 1 x 8 Ohm, 2 x 8 ohm
FX Loop(s) Yes (with mix control- 100% Dry to 100% Wet)
MIDI IN OUT THRU Yes- supports phantom power
Weight 21.5 Kg
Dimensions Width 654 x Height 279 x Depth 253
Master Section Damping and Amp Mute switch, Reverb, FX and Presence Level control
Master volume Yes - 2 (foot and MIDI switchable)
TT412 cabinets are designed to handle the wide range of output characteristics produced by the TT heads. Each TT412 cabinet is equipped with Celestion vintage 30 drivers.TT412APower RMS 240 Watts
Inputs Double (Paralleled) Jacks
Impedance 16 Ohms
Drivers 4 x 12" Celestion Vintage 30
Baffle Angled
Castors Yes
Cabinet Design Premium custom-designed plywood cabinet optimised for use with the TT series valve heads. Chrome corners, metal grip handles
Weight 45 Kg
Dimensions Width 715 x Height 715 x Depth 358
The GH50L is a single channel master volume style head with footswitchable gain. It is capable of a huge variety of sounds, from sparkling clean through powerful crunch to full on monster tones and everything in between. If tone capable of turning people's heads at 100 yards is what you're after - look no further. As well as astounding tone these heads offer a valve-coupled effects loop and link jacks for slaving several heads together. The GH50L features an ECC83 equipped preamp and EL34 output section, easily switchable for 5881's. The GH50L is designed to be used with the GS412IA and GS412IS cabinets - to enhance the amplifiers huge tonal range and produce stunning tone at any volume.
Power RMS 50 Watts
Inputs Hi & Lo Jacks
Channels 1: with footswitchable Gain
Equalisation Bass, Middle, Treble
Master Presence Control Yes
Switchable Resonance Yes
Preamp Valves Premium ECC83
Output Valves Premium EL34
Switchable valve bias (5881 EL34) Yes
Class A/B
Link Jack (Line Level Slave) Yes
Footswitch FS1 (Not included)
Speaker connections Connections for 1 x 16 ohm, 2 x 16 ohm, 1 x 8 Ohm, 2 x 8 ohm
FX Loop(s) Yes (Switchable Insert / Side Chain) with return level
Weight 20 Kg
Dimensions Width 678 x Height 240 x Depth 253
Designed to be used with the GH50L and GH100L all valve amplifiers the GS412IA (angled) offers the player a distinctly vintage sound cabinet with a nice recessed mid tone. Each mono GS412IA cabinet houses 4 x 12" 80 watt drivers and is finished in a sliver grey front fret and a black granite tolex with castors as standard. Whilst the GS412IA cabinets are designed to complement the output characteristics of the GH50L & GH100L heads they can be used with any Laney guitar head to get the tone you're looking for.
Power RMS 320 Watts
Inputs Double (Paralleled) Jacks
Impedance 16 Ohms
Drivers 4 x 12" Celestion 70 Eighty
Baffle Angled
Castors Yes
Cabinet Design Custom-designed plywood cabinet optimised for use with GH100L, GH50L and VH100R valve heads. Chrome corners, metal grip handles
Weight 38 Kg
Dimensions Width 715 x Height 715 x Depth 358
